Drive 1 Status - Seeking

Anatoly

Участник
Привет! Сбоит задание резервного копирования, которое пишет виртуальную машину на ленточную библиотеку. Бэкап идет с помощью veeam.
Veeam шлет на почту предупреждения:

18.02.09 08:49:13.54 Attention: Drive Cleaning request
Event Code: 0x82 - cleaning request
Drive number: 0x01, 1
Serial Number :
IP Address :
Firmware Revision : 6.40
Library Name : MSL2024

и вот такое
18.02.09 08:49:13.57 Attention: Drive Warn or Crit Tape Alert flag
Event Code: 0x84 - tape alert
Element number: 0x01, 1
Drive number: 0x01, 1
Tape Alert Flag: 0x14, 20

Вроде бы понятно что чистка нужна (чистящая кассета внутри есть с префиксом CLN).
Решил зайти на веб консоль библиотеки и посмотреть что там.
Смущает эта картинка и статус Drive 1 Status - Seeking.
image_429.png

Что делать?
 
выполнить чистку драйва библиотеки, повторить бэкап

Ок, пойду делать чистку Еще вот это не дает покоя
Код:
Processing full backup of FILE-SRV
TapeDrive alert: The tape drive is having problems reading data. No data has been lost, but there has been a reduction in the performance of the tape..
TapeDrive alert: The operation has stopped because an error has occurred while reading or writing data that the drive cannot correct..
TapeDrive alert: The tape is from a faulty batch or the tape drive is faulty:. Use a good tape to test the drive. If problem persists, call the tape drive supplier helpline.
TapeDrive alert: Your data is at risk:. Copy any data you require from this tape. Do not use this tape again. Restart the operation with a different tape.
TapeDrive alert: The tape drive needs cleaning:. If the operation has stopped, eject the tape and clean the drive. If the operation has not stopped, wait for it to finish and then clean the drive. Check the tape drive users manual for device specific cleaning instructions.
Unloading tape FX0013L5 from Drive 1 (Server: SB1, Library: HP MSL G3 Series 6.40, Drive ID: Tape0) to Slot 1 Error: The operation completed successfully. Unable to move tape from ChangerDrive0: changer element is empty --tr:Error code: 0x00000000 The operation completed successfully. Unable to move tape from ChangerDrive0: changer element is empty
Processing incremental backup of FILE-SRV
Хотя вроде понятно из за чего. Ладно попробую почистить ленту
 
После чистки драйва сделайте инвентаризацию библиотеки и каталогизацию всех носителей. У вас похоже не актуальные данные по кассетам -
Unable to move tape from ChangerDrive0: changer element is empty
т.е библиотека думает что там кассета а там пусто
 
Спасибо попробую позже, щас чистка только закончится..
 
Назад
Верх Низ